Dock Accessories

Includes bracket, inflatable wheel, and all fasteners.

12" Dock Wheel and a  4" Lip for Corner use.

• The Bracket which is shown as the picture for this item
• 12" Wheel, choose a color either white or black
• All fasteners and attaching hardware needed

Includes bracket, inflatable wheel, and all fasteners

12" Dock Wheel and an Outside Corner End.

• The bracket that is used as the picture for this item
• 12" Wheel  comes in either white or black which you must pick one to complete order
• All fasteners and attaching hardware needed

Includes bracket, inflatable wheel, and all fasteners

12" Wheel and Straight Bracket for a side mount configuration on your dock.

• Includes the bracket shown as the picture for this item
• 12" Dock Wheel which comes in either White or Black
• All fasteners and attaching hardware needed

Includes bracket, inflatable wheel, and all fasteners

12" Dock Wheel and  1 1/2" Lip for Corner use. Sometimes the 4" Lip is too long and interferes with the hardware, so 1 1/2" Lip will work in those cases.

• Includes bracket as shown in the picture for this item
• 12" Dock Wheel which comes in White or Black
• All fasteners and attaching hardware needed

This is a single 12" White Dock Wheel. Use this as a replacement for another wheel that you purchased with a kit, or to create your own bracket.

 No need to buy this with another kit because its already included!
 

Use the H-135 to build in a 45 degree angle on your dock to spread out the load of an attached dock section to a main dock. Use two H-B backup plates per one H-135 to strengthen the dock frame. Use 1/2" carriage bolts for assembly.

The inside corner with a 3" pipe holder replaces the standard inside corner (H-IC) and creates a place for you to use a 2-1/2" ID pipe (or less) to anchor your dock in place. With an inside corner pipe holder no anchoring hardware protrudes on the outside of your dock. When you use this hardware you will need to cut out a hole in your decking and you will also need to think about where your floats are located (if you are using floats). Use with 1/2" carriage bolts.